Recent content by wkola

im looking at lucas synthetic universal hyd oil it says it has a international harvester B6 spec. oil and also suar danfoss pumps which it the hydrostat drive that my bobcat uses.

thanks for replying

Hi All I have a 2001 773 anniversary edition 56 hp. When i bought it the guy Had not used the a/c or heater in it for 10 or 15 yrs because the fan motor was bad. So replaced it and the cleaned the evap. and heater coils and changed the filters out and in there was still freon pressure on the...

I just got the muffler today and installed it. it is a little quieter. thanks for all that replied Pat

thanks for all the replies. it doesnt seem load to me but i dont know what one should sound like with the muffler on. the guy i bought it from said it rusted out and thats why he straight piped it. seemed kind of cheap to me. so is the aftermarket muffler a good one or do i need to buy it from...

I'm working in my woods clearing brush with the brush cutter that I bought for it. Does it really matter about a spark arrestor?

I have a 773 with turbo charger that is 56 hp. when I bought this the other owner said the muffler rotted out and he installed a straight pipe were the muffler was. is this ok or do I need to install a muffler on it to make the right power output or doesn't it make a difference. just wondering...

Power King Skid Loader Oil NT is a premium universal SAE 10W30 hydraulic and hydrostatic fluid containing approximately 2,700 PPM of zinc. This high zinc content provides exceptional anti-wear protection to pumps and motors at the high pressures of modern hydrostatic systems. This oil is very...

GEAR PUMP/ TS1022 SINGLE -CAST IRON - For Ref. 1 (6677647 PUMP im pretty sure this is my pump

500k12242 should be from memory

I have a 2001 773 anniversary edition 56 hp the pump is a standard flow 16.7 gpm pump . I was wondering if another pump could be put on and get a higher gpm . I just bought a brush mower and it says 16-25 gpm and using it i notice it would slow down cutting when i cut on 2 or 3 inch trees and...

the right paddle switch is a pwm pulse width modulation switch . you can push a little or a lot with your thumb and the trigger is a on off switch. the pwm is measured by resistance. it all should run through the computer on the loader. you can measure voltage at the 10 volt wires back probe and...

sounds like you have a bad stem valve . it could be sticking or with age worn so the fluid pass threw . i found my problem and fixed it by replacing the stem valve . and the coil is rated for 10 volts max not 12 volts

disconnect one lead of the battery and put one lead of the test light on the battery lead you have off and the test light other to the post of the battery and then pull one fuse or relay at a time and the light goes out that is the circuit with the draw

yes