Recent content by walio123

Just measure oil pressure with oil pressure gauge, if it between 1 -4 bar, engine is ok - while idling must be > 0.7 on max rpm must be 2-4 . Sending unit is a pressure resistor, i can check readings if yo wish.

Send an email to [email protected]. I have it.

There is no need to pull engine out to find hydraulic leak. Just lift cab, wipe all hoses and pipes and take a good look. Under engine no any hydraulics. Usually seen when the hoses are dry. Also wipe the main hydraulic valve. When valve tears, the oil runs out under engine. I have repair manual.

There is no way to be relief valve,motors or pupms. I think you need to adjust pintle cams and bars. Did you make it?

This is a pretty old machine and it will take care of it, take good to look around it and to know what the condition is ... you will have to get your hands dirty if you want to have strong skidsteer :)

I've seen a pretty cramped system. They had added a resistor that puts the corresponding voltage on the controller and it works until the resistor is burnt because of its weak power. If they had put a powerful enough resistor, the system would work. The resistor was added to the controller's...

Just lift it all the way and run the boom all the way several times, do the same with the bucket, move the machine up and down a bit, and that should clear the air out of the system. If everything is fine the foam will disappear after a while. Do not forget to check the oil level afterwards, it...

Check lifting pump, t can cause a rapid rise in oil level/ fuel in the oil/. Remove it without removing the hoses to it and push primer bulb. If there is fuel leak tru lift pump plunger , replase it. If there no leak, check injectors.Do not try to turn the starter until you find out the cause of...

Try to adjust the linkage between the T bar and the pumps correctly, if this does not work, you probably have a weak hydromotor or a weak pump on this hydromotor

I'm glad to fix the machine without removing the solenoid :)

Check the wires and the wires conectors for a good rebound to the battery,to the starter and to ground, clean them with sand paper and try again.There may be a damaged wire or a bad, corroded or loose ground connection.

When removing the connector of seat bar sensor, the machine should not be able to move the bucket and the boom, the movement should also stop if you did not press the traction override button, the corresponding lights on the controller should not light up.If you can move the boom and the bucket...

The case drain line must be connected directly to the tank, through the filter, in some machines there is one filter in some two. The block can be used as a tee to join the lines of the two hydromotor and return to the tank through a filter. It should be free, because if it is clogged it will...

You may try to flush it with a hose inserted in the radiator and an open block drain. Take great care not to let the hose out too hard, water should not splash out of the radiator, there is a hose on the air filter nearby, and if water gets into it, it can damage the engine badly. There are also...

Head can be removed without taking engine out. Kubota are quite good engines and this is not a common problem. A problem occurs if the engine has been overheated badly or overheated several times. I've seen 2 times a badly cracked heads. Most of the time passes only by head gasket replasement...