Recent content by Trent

Hey I haven’t Doug into mine any further Hopefully this winter I’m going to switch my drive sprockets from one side to the other and see if it’s the excessive wear on the sprockets causing it I haven’t heard from anyone on this site or any other info

Hey there I have a 2012 t190 with 3500 hrs on it Machine drives great and lots of power who’ll in motion but the problem I am having is when the left track is stopped and I move right track forward it does not move smoothly it is a little jumpy and if I am in a pile of dirt stopped and move the...

So I got the fly wheel and pump drive figured out and now the machine is up and running as it should but the loader arms will not lift I currently have them on the lock cylinders and it will almost stall the engine trying to lower it but will only lift 1/4” ( not enough to release lock) and then...

Anyone able to help with how to upload photos I added a picture of my flywheel to my sig

Hmmmm well that’s not what I wanted to hear Sounds like that’s how mine is but the outside side f the cone has rubbed on the pump housing all the way around and wore a shallow groove on it Is there a spacer or something that would sit in the input shaft to stop it from touching or is there...

Can’t seem to figure out the picture but one side of the spline hub had a bit of a cone shape Does cone go towards or away from transmission It’s currently towards the transmission which I am thinking pushed the seal in to far and caused cone to run on housing?? Thanks for the seal numbers I...

So I pulled the engine out and noticed the adapter piece with spline that bolts to flywheel is rubbing in trans housing... maybe who ever switched parts on put it on backwards which also could have damaged seal I’ll try to post pictures of some one can tell me if it’s correct or not

Awesome thanks I will look at that tonight and maybe start pulling motor back out .... I just hope I’m not into pumps

Hydraulic

It’s leaking between the bell housing interbally

Good morning I bought a nh l555 without an engine in it but it came with a good used running engine Engine out of machine had already been discarded if but was a 1903 and the engine it came with is a 2204 which had the adapter and flywheel switched over already When I put the engine in...