Recent content by tomstu

I recently brought my bobcat 853h in a shop to have the axle bearings and chaincase bearings changed. They also replaced hydraulic oil filters. They put 10 gallons of hydraulic oil in hydraulic tank. When I went to pick it up it was growling. Checked tank. Nothing on lipstick. Put in about 4...

I have an 853h bobcat. What would I have to do to run log splitter?

I had this problem on a 853 bobcat. I replaced fuel line from the pump to a Jerry can hanging on the back of bobcat. Problem went away so I knew it was a problem with fuel line in tank or strainer in tank. Motor would have to be removed or raised to replace. I found a clear spot on tank and ran...

I am still looking for the cone and seal numbers for a 853 bobcat. I was given the cup number but he did not have the cone or seal numbers. Any help would be greatly appreciated.

Thank you very much.

Thank you very much. Is there any chance you can send me the number of the cup as well. I really appreciate this.

Yes I know the bearings have numbers on them but looking to get bearings and seals before I disassemble and hoping to buy from a bearing supplier. Thanks for your response.

I am looking for axle bearing and seal numbers for a 853h bobcat. A crossover to a timken, skf or any other manufacturer number would be a HUGE bonus. Thanks.

Thanks for the idea. Sounds like a good one.

OK. Thanks. I will have to leave this for awhile as I am going to be quite busy but I will try this when ready.

I will try that this afternoon but I do not think my wheels will turn. It seems like they are all locked up. Thanks for the suggestion.

I am trying to remove front drive sprocket bolts on a 853h bobcat. I have a 1 1/2 inch wrench with a 4 foot bar on it and can not budge either front sprocket bolts. Anyone have any tricks or suggestions other than a longer bar?

First time posting. I have a 853h bobcat. Last fall I replaced all 4 wheel axle seals and parked for winter. Now I have a ticking sound when going slow. 3 axles have some end float. Could I have damaged something while changing seals? Hubs were VERY tough pulling off. Also, can drive chains be...