Recent content by rar54

I will give that a try when it warms up here in Minnesota, my shed is not heated and working without gloves inorder to get your hand through that center drive opening would not be any fun. Thanks again for this information.

I have not got around to rebuilding my TM20 gas engine yet, been using it for snow removal at my shed, email me have you have and a price and will see if its in the budget this year-lol

I had a wheel bearing go out on the left front of my 1990 1835 C Uni-Loader. I removed the left side tires and the complete front left axle housing, it was very tight but I did get the chain off the sprocket, I replaced one of the bearings and race, assemble the axles with cast housing and...

Thanks for the reply guys but I have gone through everything because when I first got it 2 weeks ago it had fresh oil running down the whole front of the motor so I took the valve cover off and found the front part of the gasket had sucked in and left a gap for oil to pour out and from the build...

I can not find a source to buy rings,bearings and gaskets for a rebuild on my gas TM20 motor. It is a 3 cylinder Teledyne/Continetal gas motor 44HP my 1835C is a 1990 model with only 1400 hours but is burning oil, it does not smoke but consumes oil about 1 qt every 2 hours of operation, Does...