Recent content by powerking

brochure for model 1300 shows 50hp?? it's a 2203? kubota. the 1702 is said to have 36hp when new would this cause pump damage from too little ,i know more than 50hp would hurt pump and might break something [caused from motor not stalling out ] i was told this by a mechanic when asking if a...

looking for parts [used or parts machine] for 1300 mostly need engine mounts/drive coupling for motor-pump machine has a 1702 kubota for it will that have enough h.p.?? thanks i'm in mass.

have a 743 hyd. pump assembly with the input missing [broke off ] has all the connector fittings and the front pump too. looking for 400./ b.r.o. machine was running when coupling broke and was parted out .

i have the fuel tank [forgot if it is a split purpose] if it is seperate i do not have it .still have the cab,arms,hyd. cylinders, perkins parts , fuel and oil fiter assemblies , starter c-ya steve

i had to clean my battery ground to motor connection when i had that happen ,i added a star washer also. you will need to check the whole charging /start system .if your volt meter was showing it charging [12-14v]when last used the alternator should be fine.motor to chassis ground should be...

bobcat parts or parts machine wanted 1600 model some parts match 743 skidsteer the 1600 is a small [7000#] articulate made in 89-93 years would consider n.o.s. parts too . arms and front 1/2 needed also.

i have the arms but quik-tach is gone to boston. i have hyd.cylinders,fuel tank,perkins parts, kiki? injector pump.cab with dash. i have the tilt piston but ring at top is broke off will need new one welded on. e-mail if interested i'm in western mass.

have someparts left from 843 machine fuel tank,arms,hyd.pistons,engine parts[perkins 4 cyl.] injector pump [kiko??] cab, any interest ? i'm in mass. b.r.o. or trades

seen on some ads for motors where seller says the 2203 will fit in area ,they are more recent and common than the 1702's now anyone know the answer dealer said him or nobody at the shop knows if it will work . thanks for any help also looking for gehl dealer who at one time advertised in the new...

not sure how motor is coupled i have a 20hp onan performer with 1-7/16" shaft it has muffler /elec. fuel pump ect. not sure if there is room to put this in your machine?? the new v-motors are nice if there is a good cooling area for them . best to stay with a twin motor for less vibration