Recent content by phaeg

thanks for the advice , it did seem to be leaking so I will give it one more shot with some heat.

older 643 machine , replacing drive motor hoses that come off the left (as sitting in the machine) side of the pump , I also want to replace the o-ring on the hose fitting attached to the pump but cannot break it loose with a standard beaker bar. I don't want to break anything , should I leave...

I have an older machine that does not have a factory support for the lift arms when up for service. What is the safest way to support these I know the dealers sells something for this but wondering if a piece of schedule 80 pipe could do the trick without sacrificing safety. Is there any place...

643 , have fixed many leaks but I suspect the rear pump seal is leaking, the oil cooler is very wet. I replaced the hose that leads to it but that was not it.

is there anything else in this area that would sling oil into the fan?

What is the best way to find leaks? Is there a dye that can be added to the hyd fluid etc...?

for this type of leak is it easier to remove the pump or the motor. I have the same machine. 643. There is a major leak which I believe is the rear pump seal. Where ever it is the fan/flywheel is slinging oil up into the oil cooler and radiator. I thought the oil cooler may be leaking but my...