Recent content by oldman716

Help Support SkidSteer Forum:

  1. O

    2002 LS180 rebuilt pump [delphi 200]-[ drive on rotor broke]----idles-- 28650 RPM what did I miss

    help --the rotor broke --replaced head ---now has idle of-- 2865 -RPM --how do you adjust the metering valve -to the torque plate---can the problem be in the end cap--delphi 200 --7185/200 ---89 22 A 185W
  2. O

    delphi 200 -need adjustment info --metering valve to gov. plate

    its a delphi 200 ---7185/200 --89 22 A 185W ---i replaced the link to the metering valve --need measurement to the gov. plate ---or how to set correct distance
  3. O

    need help adjusting link to metering valve delphi 200

    I have a delphi 200 ---7185/200----89 22 A 185w --replaced the link rod to metering valve --what measurement is there to the gov. plate ---runs wide open
  4. O

    2000 NH skid steer ---Rebuilt pump --steady increase in RPM

    delphi200 --type 1262 --7185/200 -- head 906L -OFG --NH LS180 --starts --RPM increases steady --i checked in the cap --everything is in the right place and moving ---no smoke --
  5. O

    2000 NH skid steer ---Rebuilt pump --steady increase in RPM

    lucas delphi 200
  6. O

    2000 NH skid steer ---Rebuilt pump --steady increase in RPM

    i rebuilt the pump-delphi 200 --[ 2000] -the head rotor drive broke --replaced with a new head - had timing problems --finally set to 10 deg. BTDC ---AT TDC AND 10 DEG --- after start-- steady increase in RPM --slight change with throttle --seems to run wide open ----no after run when shut...
See more
Top