Recent content by NITRO

Ive found out whats wrong with it and my machine has also just gained am extra feature i thought it didnt have.... After going through the manual again, ive discovered that my float button ive been using unsuccessfuly is not the float button at all.... And the glide ride button that i thought...

Ok thanks, so it appears to be something wrong with it then. I will try to find a machine the same just to double check the boom can lower whilst pushing forward left on joystick and then see if the dealer can fix it. For what i do with windrowing manure and lift carry work it works great and...

The reason the aux (grab open/close) is acting like its dead headed is because i fitted 2 adjustable flow restricters onto the back of the bucket check valve block in an attempt to slow down the bucket grab speed. That grab is aggressive as hell and almost impossible to feather with the factory...

Ok thanks, i took the bucket off this arvo and without any attachment i raised boom a meter or so off the ground then pulled crowd rams back hard and held them there against relief. If i then try to lower boom it goes up instead of down. So it appears that either aux or crowd working against...

Ok, it appears to be a hydraulic problem. If i crowd bucket fully and hold the lever and then try to lower boom, the boom raises so i must have some sort of hydraulic backfeed problem charging my boom raise circuit while a crowd or bucket grab is in relief mode. Ive lifted the cab and looking...

Hi guys, So ive clocked up 150 hrs since Feburary on my new holland L230 and ive got an atea here that i have rough graded and just trying to learn some basic skidsteer operations like making a pad and spreading. I'm struggling to figure out how to use the 4 in one to pick up the dirt. Im either...

I found the problem. Tested the charge pressure at the brake lines and there is 400psi while machine is running in operate mode at idle and zero psi when park brake is applied so that means the park brake solenoid is working and allowing pressure into brakes and brake switch circuit. I spliced...

I have found a block on the left side of machine which has 3 solenoid valves in a row along with a brake pressure sender and a charge pressure sender switch. The middle solenoid is the brake and the front one is the 2 speed, not sure about the one at the back. The brake and pressure switches...

Ok, got my hands on a few pages from the service manual and it has a procedure to fix the error 4431. It says its a disagreement between the park brake pressure swirch and the park brake solenoid. Its either: Low charge pressure, open or shorted wire in the circuit, park brake solenoid failure...

Changed hydraulic oil filter. Still the same fault code 4431. Machine has 116 hrs on it.

Tried machine again, started it then press operate button. Park light and the upside down T comes on but if i rev engine up to 2000 rpm the lights go out? Lol wtf is wrong with it Haha.

Put cab back down and started it up and everything seemed normal, done 5 minutes work and then it beeped park light comes on along with upside down T light and aux overide flashing too. Machine keeps going while lights are on. If i press park button the lights remain lit but it the park brake...

Hi, i need some help with my 2012 L230 skidsteer. Symptoms: error code 4431 After about 70 hrs on the hr meter the display would sometimes beep after morning startup as soon as the operate button was pushed. A yellow dash light that looks like an upside down capital letter T. It would beep and...

This 4 in one bucket hydraulic couplers are a pain in the backside to re connect to the skidsteer after changing attachments. Grabbing spanners to release pressure in bucket grab is getting old fast! Whats the trick? Teied hammer and punch but you need 3 hands and a mighty heavy blow which may...

Great, ill get a standard flow one. Thanks