Recent content by MADDADDY30

Yes, sir, it is sliding in and out the up and down and back and forth is fine. I called my local new hauling dealer. They want three hundred and nine dollars per wheel 4 the Rebuild kit. Grease is coming out the casting around the rear of the hub. The chain and sprocket look brand new

Okay. So I eliminated the temperature sensor on the thermostat housing and added a manual gauge in doing so. I noticed that the panel was still reading hot. And there is a second temperature sensor which is screwed into the head above the thermostat housing. In fact, the coolant is only about a...

Welll. I haven't figured it out yet. I stayed up till 2am tearing down and putting back. Ran machine about 10 minutes and temps running 255. The coolant doesn't seem to be circulating. I bought a temp gun today. Radiator is hott on top cool on the bottom. Also had a flat. Got the machine on...

Im going to run get a ir gun in the morning. So I just ran it full throttle and within 10 minutes it was saying 255. Taking the cap off whole running and the dash reading 255 there was no eruption or much vapor. Added little more coolant. It's bouncing out the top but... I just thinking I may...

I have slid the radiator out and cleaned leaves out and sprayed out. Maybe not good enough. Ibhave not checked with an ir temp gun. Where to check and what to look for? I have the side panels on but the top screen is off. If i idle up it actually gets hotter. Air filter is new. Belt...

So I've been noticing mu machine getting pretty hott.. running today i got up to 255 within 30 minutes. Changed thermostat with oem, new gasket, no leaks, with same results. waterpump 2 years ago. I took the thermostat out completely and it's still saying 255 when running full power. Any help ...

Hey guys. So I know some of you have seen my posts and I really appreciate the replys! I've had my machine for about 4 months, been working on it since day one. I finally got her going and the dump and tilt is very slow. There's no leaks and I just rebuild the cylinders. But looking at it and my...

Thanks buddy. I fixed the cap. Co witnessed the previous location mark from the set screw.

Hey guy! I've had another thread for several weeks seeking help with a ghost leak on my 865, I thought I'd share what I found and ask some advice. So I pulled the LH pump today finding that due to a motor mount failure the bottom of the servo rubbed thru the frame causing a leak from wearing...

Ok guys! I have an update. I got all the return hoses and the suction hose made and put on today. No leaks there! But! The leak I seen prior which I added a picture at the start of this post. So what seems to be leaking is on the bottom side of what ever the big pump to the right looking under...