Recent content by LittleE

Thanks for the insight and link brdgbldr. I did go to the site and order the spline coupler adapter. It is $150.99, about $50 cheaper than through a dealership and as you pointed out, no shipping charge, so probably about a $70 savings. Note: While doing my research, the original part number...

Hi again, earlier I was looking for a thick washer for the spline coupler. I ended up just finding an outfit that makes various size thick washers. Since mine looked a bit abused, I went with a stainless steel washer of the same thickness and inner diameter, but 1/8 inch larger on the outer...

Thanks everyone for the quick replies. I have a paper copy of the parts catalog but couldn't find it in there. I'll check the posted link. There seems to be very little coverage, in either the shop manual, or the parts catalog, for the coupling parts, motor to hydrostat. I can try lps, maybe...

Does anyone know the part number or where to find the thick washer in the picture below, (captured from another poster). This washer and bolt are what clamp the spline coupler onto the hydrostat pump shaft. Mine is somewhat deformed and I would really like to replace it. Thanks in advance for...

Hello everyone. I'm a firmware engineer with a large firm, writing embedded software for the last 35+ years. I have a little acreage where I put up a little hay. I grew up on a farm and was never able to get the joy of working the land out of my system. I recognized early on however, that...