Recent content by Jbohannon

I am still having issues with the right side drive motor. A couple of years ago my motor on that side went bad and I replaced it. From the very beginning it was not as stong as the left side and not long after it would not drive at all. So then I purchased a used one since this is an old machine...

Thanks for the help I will do it that way. Now I have found something else. I blocked up both wheels on that side and removed the chain case cover. When I get in the seat and start engine and move that side lever wheels will not turn. They move about and each or so either way and then just stop...

Thanks for the help

I am about to replace the right side drive motor on a 2050 Mustang. I have two questions. Does it come out from inside the machine or underneath? If underneath what is a good way to block skid steer up ? Thanks

I have just rebuilt or replaced both drive motors. The left was rebuilt I bought a new one for right. The right was not turning so I replaced it and mechanic said the other needed repair. So I did. When I got it back both worked now the right has slowly stopped working again. I bought the motor...

I have a Mustang 2050 that shoots fluid out the side of the drive motor when under pressure and a little flow under no pressure. can this be repaired ?

I have a Mustang 2050 that I am pretty sure the wheel bearings are out on the rear wheel. Is it a hard job to replace them. I tried to go to the Mustang forum but could not start new thread. Thanks, Joe B.

Thanks I will try that.

Yes the tilt and raise and lower bucket foot pedals have cables going to the valve. Now they are heavy duty approx. 1/4" thick . I just do not know how to lubricate. Thanks.

Lately I have noticed my tilt foot pedal is very hard to move up and down and sticks in the on postion. After removing the floor cover I have narrowed it down to the cable. Can they be lubricated. What is wrong with it. Is it hard to replace. Thanks.