thanks i was afraid of that . i noticed that the pin is rotating even with the bolt that holds it . so i ordered the bushing and new pin and seals . can i just build up weld and ream it till it is tite?
im going to try removing the bushings first . if that doesn't work then i buy the weld in repair bushings . i don't have a plasma cutter so i was going to use cutting rods .it will not be as clean but should work are there any hidden welds or are they all accessible ?
thanks for the reply . i dont know if the old bushings are still there but i do know that there is not enough room for the new ones . i looked at maybe doing the weld in ones and it looked like a lot of cutting to remove the original . i can weld in the new ones but i was concerned about the...
has anyone tried the weldin replacement bushing . if so how hard was it to do? does anyone have a bobtach for sale? has anyone bouight a new bobtach? if so how much was it? mine has been pretty loose since i bought it and im trying to tighten it back up . i bought the bushing but cant get the...
ok the manual only shows one bolt on the right which is missing . then a couple on the left which go to the hydrostatic mounting flange which are still intact . so Monday I will order two of the one that is missing and reinstall. then I will check operation and report back thanks
ok the pump is clean and no leaks are present . the mounting bolt on the right front is missing I'm gonna order two bolts and a tilt cylinder repair kit because that blew out and It's leaking too much to run the machine at the moment . how many bolts are there on the pumps ?
ok both sides are done . I put new seals in both drive motors replaced both inline filters and replaced both motor carrier seals . I found one of the hoses going to the inline filter was leaking and replaced that also . also new hydraulic fluid and filter and oil in chain case .new air cleaner ...
I bought this a couple yrs ago . when I bought it . it would start and when you moved it would stall . I changed the carb and gasket . solve that problem . I changed the plugs , air cleaner . I change the oil twice a year because of moisture build up .I only put about 20 - 30 hrs a year on it...