Recent content by Hx65363

Help Support SkidSteer Forum:

  1. H

    Aux Hydraulic Lx565

    Lx 565, I recently purchased a grapple for our skid steer, and discovered that the aux valve is stuck, rusted and pitted, so I'm not sure if I even want it to move at this point. Does anyone have a good resource for replacement spools, I've looked online and haven't found the one I need, I've...
  2. H

    Lx565

    Well I tried that, and it did not work when it beeped and flashed the dash, then I was unable to unhook the seatbelt and re-hook it so the foot pedals to release. So back to the drawing board!
  3. H

    Lx565

    I have a Lx 565 I have recently been having a problem with a very brief beep then the info center (dash) lights up then the pedals lock I have to unhook the seatbelt hook the seatbelt and go on, its got to a point that it's not worth using the skidder at all. I have checked and rechecked...
  4. H

    Lx565 starts wont run

    And if I leave it in service mode it will run, but when I flip it to run it dies
  5. H

    Lx565 starts wont run

    Mike10 Witch relay is the interlock, mind you I don't have a diagram.
  6. H

    Lx565 starts wont run

    Thanks Mike10 I'll check it out!
  7. H

    Lx565 starts wont run

    Thanks flyerdan I'll check But it will run in the service position .
  8. H

    Lx565 starts wont run

    I need to know where to check my lx565 will start but when I let off of the key it dies what do I check?
  9. H

    Wiring

    New to the forum, I have a Lx565, mice have eaten the wires up by the eic I've replaced the bad wires and at some point before, someone has replaced wires at the plug where it connects to the eic. I need a pic or diagram of the wire arrangement, I don't know where the green wire goes. And would...
Top