Recent content by Hawker74

Thank you, I'll check this out!

Thanks for the advice! I'll look into this. Cheers

Hey guys, sorry if this question has been covered before. I have a 2009 Bobcat S205. I have a couple of aftermarket attachments like a snow blower and a snow plow. When connected, I get full hydraulic pressure to the cylinder ram, as an example, on the angle adjustment ram for the snow plow...

Thanks for the reply guys. Sounds like maybe the easiest and safest is just to wire direct to the battery. I cant see a reason for fuse protection so I think this will work fine. Thanks again for info and ideas.

Hey all, I have 2008 S205 and I am hard-wiring the harness provided to operate a Schulte Snowblower. I have routed the harness through the engine compartment and up along the left lift arm the same route that the 7-pin connector harness follows. The secondary leads go up through the cab to a...

Have since sold the machine and haven't had a chance to run a tank through it. I would suspect that it would have been quite good on gas. Ya, I have to agree with you guys about Kohler. I don't know much about about them but from what every here says they sound like a pretty good engine. I won't...

I'll try to get some pics to ya if I can find them on my computer. My computer is as organised as my shop! lol

I finally got my azz in gear and installed the Honda engine. It went in very well with minimal farting around. It purrs like a kitten now. An excellent fit for this machine! Thanks again Ken!

I will be sure to let you know how well the install goes. I am in Warman, Sask., Ken...

Hi again guys, for interest sake, I have taken Ken's advice and checked out www.smallenginewarehouse.com . I originally began looking at the Honda 650X engine at PrincessAuto here in Canada. It seemed to be a good match. It was around $2400CAD. I did a litle bit more research and found that as...

Thanks for all the input guys! I'm not neccessarily against Kohler, I just don't know very much about them except they also make toilets. A guy at the local rental shop asked me what kind of motor was in it. When I told him it was a Kohler he said - " good luck with that, they usually blow up...

Hi everyone, The Kohler in my 540 when kaputz. Instead of rebuilding the POS I want to replace it with a Toyota 22R engine or something. I am looking for ideas, suggestions or any tips from anyone who may have already done this. anyone? anyone? Thanks very much!