Recent content by drewandtrey123

You are correct. I rigged up a jumper wire and it unlocked briefly. Then it went up in smoke and was totaly destroyed. I purchased a new valve and solnoid for $80. What a pain to get the old one out because it is undet the tank behind the seat with hoses all in the way. I removed the tank which...

I personally would not weld the teeth. If you have a spare bucket lying around its no big deal. but if it is your only bucket some times you are better with out the teeth like smoothing dirt. I have a tooth bar and it is two bolts on each side of the bucket and works great. The teeth can be...

You could use button head or flat head. The flahole foe flat heasd will have to be chanfered before they will rest flat. I do not know how thich the metal is you are putting the bolts in but you must keep that in mind. I can get you a few if you aree unable to find them.

The Bics system is working and the cause of my headackes. The bar and seat are working and lights are on when the are suppose to be on. The valve light is blinking and the manul says that valve is open or valve output is shorted or valve is grounded to battery. I have had no luck tracking the...

My cat has failed again. I have a 753. The bucket will not tilt and the boom will not rise as if it were locked. The Bobcat has a BICS system and the light at the control valve will not come on. Any help will be apreciated

I put the bobcat in the shop today I will update when I hear the results.

Went to buy a manual today just my luck they were out of stock. I do have another symptom that I left out that may be very important. There is fluid leaking out of the cap where you check you hydraulic fluid. I am working on a hill and the fluid is not over filled. I have came to the conclusion...

I really do not know the year model but serial is 572726055 C series. I am going to replace the filter and fluid today in hope that it will help.

I have not got a manual yet I saw one on Ebay for 80 bucks which is probably a fair price. Would you reccomend that I remove the motor and clean out. I assume this valve exits or enters the block on top of the motor. There are several hoses there. Thanks again.

I was a little low on hyd fluid in the tank behind the seat. My aux fittings leak a little when using the grapple. I added som hyd fluid. I have read that it is too thin that I should use motor oil. Could this be a cause?

I have a 1999 753 I have been using it to clear some land I purchased. The Bobcat has functioned great until know. The left side steering is no working as desgned. When I hold both handles back and try to drag the bucket the right wheels turn and will pull the machine but not strait. The left...

I am a rookie and have not had my machine that long. I have recent started to leak. There is fluid coming out of my right front wheel. I am feel it is a seal but I am unable to determine what kind of fluid it is. The Hyd. fluid is full. Where is the fluing coming from and how do I properly check...