Recent content by dougbigfoot

Took it to Bobcat Fargo and they could get it to do exactly what I described. Said it would only do it when executing a left turn! Checked out sensors, coils, wiring and could find nothing. Decided to try using their test panel to rule that out. Turns out my toolcat was too old to accept their...

Moving dirt about 400’ using rabbit mode, disengage when loading and dumping. At a certain point when I disengage it would travel raggedly then stop travel and get the red warning symbol. Restart then it worked again for a short period. Finally got to the point where it will only engage for a...

Thanks for the reply! The original motors have two main ports and two case drains on each motor. The replacement has only one case drain. I stopped into local bobcat dealer and am told it should work fine. I will just plug off the extra tap.

I put the same post in general repair topic should have done that in the first place sorry

Hi, 763 drive motor is bad. Got one from a salvage machine with numbers that say it should work. Problem! my motor has two return ports that hook together. Replacement has only one. Will this be an issue. I can make the plumbing work. doug

Will a cab kit from a 641 fit on a 853?

I have an erskine snowblower with a 105-1074 charlynn motor. It does not work with my 853 bobcat. I need a 105-1072 motor. Will buy correct motor and sell mine.

thanks, no, i don't have the left hand switches. that is one option I am considering. any sources for used parts available?

I want to wire a fuse holder into the existing system on my 853. I am adding two momentary switches on a panel in the cab that will operate the chute adjustment solenoids. Are there any switched wires in the cab or do I have to find a relay in the engine compartment? doug