Recent content by cheesecurd

Have a 553F that has BICS. no seat sensor. Just lapbar light, traction light, boom valve light, power and system activated lights. i jumped right in and continuity tested lap bar sensor wires to bics connector and all seem good. out of habit i never checked anything with lapbar up only with...

Another odd thing i noticed, when you curl fully and send bucket circuit over relief it raises booms. any ideas?

it is not ach machine. it is standard old bobcat manual levers for driving and pedals for loader functions.

Gents have a high houred S185 hand and foot. Both tilt and lift functions settle rapidly while using. Doesn’t settle when turned off with boom up so i’d say it’s not internal cylinder leakage. next step is capping off boom over ride valve. any other ideas? load check valves? spools?

Gents, have a 2011 S650 std flow unit that has “slow” flow at aux circuit. also seems to not hold say when you squeeze grapple closed—it doesn’t hold anything tightly. Any ideas?

High houred 2005 S185 had what I thought to be a rear main seal go out. Pulled out batter, belt tensioner, belt, flywheel and got a little surprise. Turns out it was the bolts that hold the aluminum cover (that contains the rear main seal) back out and separate from the block allowing engine oil...