Recent content by bwbigred

I have an early 2000's bobcat T 300 with the keyless start system. Out of nowhere every once and a while the machine shuts off. When I go to try starting it the screen lights up and then goes blank almost like it's losing power. Sometimes it'll happen often and other times it won't happen for a...

It did seem better once it heated up but still did it once and a while very weird and like I said it only effected the boom lowering nothing else

When it did it a few times I hit the button for the aux and it stopped and other times it didn't help I have not had it on in a long time unless from moving th pilot control something inside is loose and kicking it on

I have an early cat 236 skid steer and went to use it today and while I was running it I went to lower boom slowly and it would not go only if I pushed it all the way it dropped fast and was jerky then it clearing up was good for a while and. Did it again. When it happens it sounds like the...

this is true i will check, is there anything that has to do with a pressure relief valve somone said something about that before

i never used the aux hydro i think it is the two button on the right joystick i think the machine would stall out of that was stuck and nothing hooked to it if i remember correctly i tried it the other day just to see

i have a 04 cat 257b recently when going into a pile of dirt i have been hearing a banging noise from the right side like a thumping sounds like hydro now the next issue is when i go to lift something it has like no power and you hear a thumping coming from the right side i dont know what part...

There were no shims when I took the old one out I heard someone said cyl1 had to be at top dead center I just don't want to mess anything up

just got a new injection pump for my mt 55 which has a d902 3 cyl kubota diesel, before i install it i heard it needs to be timed correctly before it is installed please need help would like to do this project this weekend thanks

just got this machine couple days ago went to shut it off and machine is still running had to put parking brake onn and hit controls hard to stall motor does anyone have any ideas what it is thanks