Recent content by bvinson9

Yes i replaced that as well.

Good morning, I recently bought a 1998 773 with a kubota engine in it. I have been having issues with lose of power after about 30 minutes of use. Its will start to bog to the point of shutting off if I have the drive sticks pressed and when I release them it will go back to normal throttle...

Thanks a lot!

Guys, Thanks for you guys help. I was able to get nut loose using a pipe as a cheater bar. I also discovered that the back wheel bearing was bad as well. ( Pretty much non existent) so i pulled the back axle as well. I did an inspection of the left side wheel bearings and they looked okay but i...

Thanks

Thanks

Thanks. I appreciate it

Good Morning, I’m in the process of changing a bad wheel bearing and have a question about the sprocket nut in the chain case. Are these reverse threads? Having a hard time getting it to break loose. Thanks

Thanks. Im trying to remove the main 1 1/2 “ nut that holds the hub on. Are these reverse threads? It doesn’t wanna budge.

Thanks… So should i go ahead and change the bearings as well?

I put 10w30 oil.

Good Evening, I drained and changed my chain case oil today on my 773 and now I have oil leaking around all four axles. Any opinions on what is causing this? I was thinking maybe oil seals? I bought this machine used and it is a 1997 model. Thanks

Thanks

I recently purchased a used 1997 bobcat 773. The owner informed me that it would need a fuel shut off solenoid because it wasn’t engaging and had to be pushed in by hand to start the machine. I purchased one and installed but the new one is still not engaging. Any ideas on what else it could be...