Recent content by bumpytruck

Installed a new battery,problem is fixed.

I searched on here and could not find exactly my issue. I sit in the machine,put the seat belt on and start the machine. The pedals do not unlock. With the machine still running I unlatch the seat belt and re latch it and the pedals are free and the machine works fine. It works fine until i shut...

So far the new starter seems to be working.I have not had any problems as of yet. I was able to purchase a new starter off of e-bay for $105 shipped to my door.

I was unable to find that in a search."lx665 wont start". However I had my son try to start the machine and hold the key in the start position,and at that point I gently taped on the starter with a hammer,after several taps the machine turned over and started.With this information do you believe...

I seem to have the same problem however my machine will not start in the service mode either.After several attempts it finally engaes and starts normally as it should.It clicks just like this one does.I have seen no updates on this thread as to what the solution was.Anybody with advice please...

Well after measuring things up,heres what I did. I went out and purhased a 3/4" x 7" bolt and nut-$8 . I then came home and drilled out the door hinge and the steel bushing on the machine itself. 3/4" Drill - about $30. I had one on hand.Greased it and reassembled it.It works like brand new.The...

I just spoke with my dealer. He told me that they drill out the hole on the door side of the hinge and put the next size up bolt in its place.He told me the bushing is made of steel and most often does not were out.I'll be checking mine in the AM.

Can anybody tell me if there is supposed to be a bushing of some kind in the hinge for the engine compartment rear door.The bolt on mine seems to be tight, but the door moves up and down about a 1" or better.I have to pull up on it when I latch it.

I figured that the brake lever that you pull up on was popping up when you drive and bounce around.So I welded a little tab on the machine and installed a spring,to keep the lever down while the machine was in use. But the problem still persists.I don't know if it is from having the brake on...

I have a 99 665 with about 1500hrs. I owned it since new. The problem is with the parking brake. Ihad it back 3 times in the first year,and the dealer was unhelpful to say the least."It was out of adjustment" Was all I heard.They said I must be running it with the brake on.I took it in the...