Recent content by bubba24

It has been quite a while since I rebuilt my swing cylinder, but here it goes from memory. The swing cylinder on my 709 has a plate behind it that is cupped to fit the round backside of the cylinder. There are some thin shims behind that as well. Seems like there are several 3/8 bolts that hold...

has anyone installed aftermarket fuel gauge on a 763g ? mine works but is not accurate. considering trying to put new gauge in right hand key panel if there is room for it. thoughts welcome ! thanks, bubba

i ordered new pickup tube kit from bobcat. also ordered new elbow and the hose. i actually got filter, a grommet, 2 clamps and a piece of clear tubing in the kit. the fitting and tube ordered were a metal elbow and a piece of hard black plastic with angle cut on one end. i cleaned and blew out...

i think it's a good possibility that is my problem. i'll gonna change it out in the next few days and i'll come back and let you know. thanks for the tip. bubba

hey all, i have a 2002 763g with bics system. fuel gauge used to work fine, down to the low fuel light coming on once in a while. now it seems to work only on the upper end from half tank to full, rarely drops below half tank. i have run out of fuel a time or two and now carry 5 gal jug of fuel...

if anyone else bought one of these auger/planers i would love to know about your experience with it. thanks bubba

i know this post is almost 2 years old. i was wondering if you bought the stump auger and if so, how has it worked out for you. considering one myself. thanks bubba

6674209 is what my book shows for 2000 763G

sorry, but i forgot to put a subject for my post. i cannot find a way to edit/correct this. maybe one of the mods can correct it. thanks, bubba24

hey guys, i have a Bradco 617 trencher for my bobcat. i want to upgrade the crumber to the one used on the Bradco 625 trencher. i need some measurements from the 625 crumber bar to get this in the correct position. if you own one of the 625 models, i need the measurement from the end of crumber...

thanks for the input. this thing is kicking my butt. i've looked at all the grounds, connectors and wires. nothing yet. tinkered with it over an hour yesterday and never got lap bar light to come on for more than a few seconds. it just intermittently comes on and goes off with no apparent...

hey all. great info here. spent many hours reading and absorbing . i am working on a early 2000 963. originally i could turn on key, lower seat bar and nothing would work. crank it up and let if run for a few minutes and finally seat bar light comes on, push green button and it works the rest of...

hey guys, i have a 709 backhoe that i'm gonna have to replace the hoses that pass to either side of the swing pin and go up the main boom. 3 on each side of the pin. i'd like to have them made up and ready. anybody know what the lengths are ? 4 of them appear to be the same length with 2 longer...