Recent content by Bisonhunter

Did you order or find a black magic box yet. I have one taken off yesterday that I would send off in exchange for a forum donation. It ran from seven pin to four hydraforce coils.

I am currently doing the opposite of your project which is connecting a low option bobcat with no black magic box to a snowblower with a bmb. The seven pin connector does not put out "clean voltage" that is easily used. You need one of skidsteer solutions boxes and that would give you the 12...

The "steering " oil is in the "chain case" between your feet. Search this forum for some pictures and chain case stories. It will all come clear. My 753 is older so no help on the codes. Good luck.

Good idea with the cross over relief. I got a screaming deal on the blower and buying a new motor is not a problem. I am just not getting any distance out of the unit now (10 feet) and it could be the existing motor has a fair amount of wear. What I really need is distance. I'll only be blowing...

I can tell this is not your first dance. Flow pressure tested today and got just what you saw speced out. 13 gpm at full throttle and 2400. The current motor is directly coupled to the fan ( the loegering has that fan that works like a paddle wheel but it does allow for bearings on both sides of...

Thanks for the input. I tried that number again same answer,Loegering sold to Cat so call your local Cat dealer. Apparently Cat never made a low volume blower so no optional motors were specified. I did get a knowledgeable mechanic and talked application with him. It seems that if you go over...

I believe I need to change the auger motor on my Loegering snowblower to match the flow from a 753c It has a 104-1093 20gpm currently and the 103-1537 15 gpm motor seems to be the best choice to get the speed suggested here in the forum. Question is the max rated psi for this series pump is 2000...

you don't have to apologize when you are sh*t hot. I never sat in a bobcat before buying my 753 but adjusted the neutral, added auxiliary lines (an option not taken on original machine) replaced motor seals including new case drain filters, did the 1000 hour service and am now trouble shooting...

Following up, I got a parts manual from my bobcat supplier for 86$ I wanted a cd but got a printed version which because of the sheer number of pages is actually better than the cd. It's worth every penny

I purchased a 753 service manual from Pro- Service on ebay for 35$ in cd form that is excellent. A parts manual from "trade bits" did not include all schematics so was worthless. Still looking for a parts manual,