Recent content by BijouHills54

I found all parts through Reliance Parts & Northern Power Products but they are limited supply at both places but got parts, machine work done and back together and ready to reinstall in loader. Thanks

We pop tested the injectors they are within the specs for cracking pressurre we determined it is the advance in the injection pump.

I have a 853 that has a miss at high idle anything above 2200 rpm, I think it is straving for fuel, we replaced the fuel filter, and fuel lines and pick-up tube & screen in the tank and also put on electric fuel pump, we have plenty of fuel at injection pump, it starts fine but misses sounds...

I am looking for a couple of pump rotating groups part # 272400 they are no longer supplied by New Holland they are obsolete and no NOS parts can be found they are used in the small frame skid steers L225, L325 L425, & L445 loaders that were built from 1977-1981 any help on finding parts or...

Check if you have voltage to the resistor below fuse box in engine compartment you will hve 12 volts on one side and about 8-9 volts on other side and I think its the the yellow/dark blue wire on alternator with female spade end I had and LX885 that would not charge and the yellow/dark blue...

Call All All States AG Part 1-877-530-4430 there are two diffrent ones used depending on serial number of loader Part # 699154 befoe S/N 717400 Part # 9609348 after S/N 717700 they are avaiable through New holland parts yet but very spendy also shaft Part number 274905 is avaialbe at Messisks...

There is an oring part number 272310 that goes on flange of the pump

Depends where you are from I would call All States AG / ASAP parts they have numerous salvage yards in the Midwest USA, Wegners Myerstown PA, or Vanderhaags truck salvage in Spencer, IA they all have the large fram LX/ LS loaders parted out.

That loader was built in Oakes ND by Lahman manf finding parts is impossible but if you new hydro pumps rebuilt call Hydro Service Roland IA 1-388-4096 they have a lot of new old stock parts and have helped me out on older new holland loaders or call this guy Leroy Olsen Parker SD...

If you have oil comming out of gearbox the hydrostatic input shaft seals are leaking, you need to pull pumps and replace seals there are no check valves on case drain, also the gear box uses 80W-90 gear lube and hydraulic use 10W-30 diesel oil.

you could try Engine Rebuilders in Oakes ND they do not supply a drop in motor but do rebuild Wisconsin Motors in the past I have used a couple of VH4D engines from there and had good results, the problem is finding parts and the cost of them any more and finding a good usewd one is about...

Thank you for the information on the valve, I have a cylinder, triangular blocks & the parts list the valve is the biggest cost New holland wants $899.00 this will make it lot cheaper and I used to mount the valve behind the fender instead of mount plate then all had to do was run hoses down the...

I had a dead one in the shop and used a set of car dollies to get it on a rollback worked great.

Does anyone know where I can find good engine for 632 Bobcat it has a 1.6-liter Ford Model # 2274E, customer does not want to spend a fortune and or repower with different motor, I have looked for Reman short blocks, but no one supplies them anymore any suggestions?