Recent content by Bertdownton

Looks like I finally had chance to work on this machine last week, after doing multiple tests and pressure tests on hydraulics it was determined to be a mechanical fault, ended up removing engine and replacing the the nylon drive gear on the flywheel, it had stripped causing the main hydrostatic...

Thanks Bobcat, the bar switch, seat switch and parking switch all work fine and electrical current running through them, we even bypassed all switches, seems like no hydraulics going to both joy sticks, looks like I will have to work backwards from the joysticks.

Good day, I have this 2006 262B 2 speed skid steer, start engine, bring safety bar down, release parking brake switch and we have no controls for bucket or drive, up or down etc, any ideas?

Ok, finally got back together, the machine now goes backwards and forwards but when you pull right lever back it wants to turn to the right, I believe it is just adjustment, motors does not want to stall, & what do you call a stat ? Do you have an adjustment guide to make sure it's done...

The pump is off and I have ordered the valves anyway, the symptoms are not reversing when pulling right lever back, , we have replaced the 2 speed hydraulic motor as the internal drive had broken and bypassing, so we then removed hydrostatic main valve and stripped cleaned and replacing...

Had a good look, the main valve has to come out, you are correct, there are 2 at the top and 2 at the bottom, nasty job, I will tackle it next weekend

Good day all, need to check the hydraulic relief/replenishing valves on a S250 bobcat, 2 speed unit, I know they are inside the main hydrostic pump, can they be removed or checked with the valve still on the skidsteeror does the valve need to be removed as it is a major job, I would appreciate...

After one week they finally cross referenced the serial number with the build sheet and gave me a breakdown of the part numbers required, looks like the parts are nearly as expensive as the motor its self by the time you rebuild the motor with new parts the labor outweighs a new part. now its...

No we haven't tried them, I tried the local dealer and they told me there were 3 different hydraulic motors used that year so we are working on getting the correct part, most common motor is $4,700 Candian dollars, any help on parts would be good, thanks

found the problem & hopefully it will help others, right side hydraulic motor inner vane was broken causing oil to bypass, now finding parts.

Good morning, we have an S250 that will not reverse in 2 speed mode when the right lever is pulled back, when the left lever is pulled back it reverses fine, items looked at are: adjusted all linkages to bobcat spec using service sheet from manual, repaired hydraulic leak, changed hydraulic...