Recent content by awschucks

HI, The linkage going to the transmission is fine. It has full travel. If it was the motor, wouldn't it be weak in forward? Dave

I've got an 1845C that has an issue. Every thing works fine when going forward, but when I go into reverse the left side seems to run slower than the right. I've checked under the seat and the linkage seems to be push the control cylinder all of the way. I'm assuming that there is an adjustment...

HI, I've got a Case 1845C that has an issue with reverse on on side. When I go forward everything is fine, suggesting that the motor is OK. But when I backup the left side does not keep up with the right. Gets worse when it gets hot. Seems like there it not enough pressure/flow in reverse. Any...

I've got an 1845C that seems to have good pressure (speed) in forward and when using the hydraulics. When I go in reverse, the machine seems slow and if I use the Aux or bucket the machine seems to run out of volume or pressure as it barely moves. Is there some type of flow adjustment or...

HI, I am having a problem getting the float to work. I have jammed the handle into the float position for an hour or more and no float. Adjusted the connection to the spool to make sure I was getting enough throw and still no float. Any ideas? I want to add a heater, but am not sure where to...

HI, Yes, I have the keyless option. When you push the stop button, all of the lights on the left and right panels go out, but the motor keep running. The fuel solenoid relay does not get a signal from the controller, so I would say the controller has a problem. When I jump the fuel relay, the...

I've got a T200 that won't shut off. I have tested teh fuel shut off solenoid and the appropriate relay and they are working fine. It appears that the computer is not sending out the signal to shut off the motor. Now what? I asume it will be over a thousend for the computer. Does any one know if...

The BobCat is on it's way. Thanks for the help skid steer forum.. Dave

The skid is on it's way. Thyanks for the help. Dave

HI, I'm looking for some help in moving a Bobcat T200 from Clarksville TN 37327 to Cottage Grove MN 55016. Thanks for any help that you can point me to. Both ends have a loading dock available, so an enclosed semi or flat bed would work. Dave

HI, I am wondering if anyone has any help in moving a T200 from Cleveland TN to Cottage Grove MN? Thx, Dave

HI, I was asking about the drive hub. Dave

Hi, I see in the service manual that Bobcat calls for 10w-40 oil in the track drive sprockets, but on several other forums I am reading that they require an expensive 90W-140 synthetic. Which is right? Dave

HI, I have a Bobcat T200 and am wondering if I can switch from the 18" tracks that are on the machine now to 13" tracks? Thx, Dave