Recent content by 1965

Something else, if your running taxed fuel like in autos it’s ultra low sulfur and it needs added lubricant. These machines built back then wasn’t designed for this new fuel.

Sounds like governor to me. The pump is just the unit that the fuel lines go to. It’s 4 nuts that hold the pump to the governor housing. You can remove it either way. Most fuel shops want just the pump. No timing involved removing just pump. Need to make sure the fuel rod is good and free. My...

I bought an actuator and controller from a salvage yard. I had taken the end off the actuator and got it going for little while but couldn’t do it again, so I replaced it first & no change. Throwing same code. So I put the controller on and fixed it. Did the book calibration and I’m going to run it.

It ended up being controller. Fixed

Controller fixed it

Is it anyway I can check the controller besides taking to dealer? ACS T250 I’ve been fighting a actuator code, I’ve swapped actuators from one to other, code would follow showing me bad actuator. It was too late to order so I decided to open bad actuator up. Anyway mounted it up and had back off...

Thanks for reply. I checked the spools movement and they seem free and tension seems same. The lift moves back smoothly to float, both seem even when in neutral position. I was pressed for time yesterday, I’m going back through what I did. I feel it’s something besides the actuators because I’ve...

Dug a little deeper. Found loose pin in connection that I think fixed the 32-50 code. I now have moved back to the 32-39 code. It changes when I swap plugs on actuators to 32-34, but I had already swapped the actuators. It (code) is staying with the harness on the lift. I’ve had both actuators...

I ended up buying several pieces from them, the guy was hard to catch & get in touch with. I drove down there and dealt. Anyways everything seems good but I haven’t used any of it a bunch. I did get a HD brush cutter & really happy so far with it. Bought 2 different buckets, 1 severe duty with...

Originally I got code 32-39 (ACS Lift actuator not in neutral). I unhooked actuators and cleaned plugs on both (they had little green in them). Hooked back up and I’ve got code 32-50 (ACS Tilt actuator short to ground). I have swapped plugs and also swapped the actuators and still just get the...

Thanks for the reply; I’ve talked with them twice & called back & left message also texted them. So I got leary of them; I had got them to quote me on big order also & I was calling to confirm order & to change couple of things. You made me feel better so maybe I’ll call them back now

Anybody ever heard or dealt with these guys? There in western Georgia; would like to hear some feedback. Thanks

Anybody ever use or dealt with these folks; they are said to be in western Georgia. Would like to hear feed back Thanks

I looked at the pump earlier & didn’t think it was hi flow; but my light would light up when you mashed the button; I called & they confirmed it isn’t hi flow

Thank you