lx565 error code

[bozz131]

i have a 1999 lx565 skid steer. After having one of the lines to the bucket burst, I replaced and filled fluid back to levels. A few days after this incident I was running machine for approx. an hour when the stop indicator and the top left error light (red with gear and drop of oil inside). machine started to bog then stalled out. Starts right back up but error code pops back up within a couple minutes. If machine sets overnight, I can get approx. 20 minutes of run time before error codes rear their ugly heads again. I am a novice to skid loaders so any help would be much appreciated.

 

[Mike10]

The light is for the hydrostat charge pressure. You need to replace the oil pressure sender. Remove the right side engine panel. Just below the hydraulic filter base you will see a sender pointing straight out. It should have two terminals on it.

 

[bozz131]

The light is for the hydrostat charge pressure. You need to replace the oil pressure sender. Remove the right side engine panel. Just below the hydraulic filter base you will see a sender pointing straight out. It should have two terminals on it.

would that be the pressure switch so many have problems with? Do wheels have to come off for access?

 

[Mike10]

would that be the pressure switch so many have problems with? Do wheels have to come off for access?

Probably. Just remove the right engine side panel and look at the hydraulic oil filter. You should see the switch sticking straight out at you.

 

[bozz131]

Probably. Just remove the right engine side panel and look at the hydraulic oil filter. You should see the switch sticking straight out at you.

Thanks Mike10, new switch solved problem. Appreciate the help!