Hi new here, great site by the way. I used a TL130 this weekend to clean up some storm debris. The machine seemed to work ok but it seemed a little down on power at times especially when backing up. I also noticed that at times the 4 in 1 bucket would open on it's own as I backed up the machine. It didn't do it all the time but it always seemed to do it at the wrong time as the ground was really soft and when this happened it would slow the machine enough to where it would get stuck. Then I would have to mess with it to get it out. When it would get mired down and tried to help push it out with the bucket as I backed up the machine would stall. It would start back up but cut right off. After doing this several times it would finally start and keep running but if I was not really careful it would cut off again over and over until I could finally walk it out. Once I was back on good ground it would move along fine until the next time. The bucket opening by itself was really a pain to deal with and as I said it didn't do it all the time, just in spells. Any ideas?? Oh, When it first did this, the down on power part I removed the water separator and cleaned it. There was a small amount of water but not enough to cause problems and I also drained some fuel from the tank and it looked good also. I know it's just a 4 cylinder but at times it just seemed to be struggling and the RPM's just did not seem to be there. I'm wondering if the hydraulics are not working like they should and causing the machine to bog a little.