Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
track removal on T-250
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Fishfiles" data-source="post: 16407" data-attributes="member: 782"><p>there are quite a few ways to skin a cat , what do you have to work with , another Bobcat with forks , an excavator or a forklift , or do you want to do it strickly by hand , which you will need a pry bar , a 2 x 4 , a way to jack the machine off the ground and a operator or if you are all alone a broom stick to stick thru the cage and active the travel lever , put the 2 x4 in between the front idler and the track after you take out the bleeder screw and remove the bottom bolt completely from the front plate on side the track frame , if not the bolt sticks thru the frame and the adjuster will hit it and not allow it to go all the way back , roll the track and the 2x4 will lift the track up on top the idle , it will loosen the track and make it easy to put a bar thru a hole in the middle of the track and pry against the idler as it is turned and it will jump off , use the bar in between the sprocket and the track to get it off there , you need to have it ja cked up high enough to clear the track guides under the rear idler</p></blockquote><p></p>
[QUOTE="Fishfiles, post: 16407, member: 782"] there are quite a few ways to skin a cat , what do you have to work with , another Bobcat with forks , an excavator or a forklift , or do you want to do it strickly by hand , which you will need a pry bar , a 2 x 4 , a way to jack the machine off the ground and a operator or if you are all alone a broom stick to stick thru the cage and active the travel lever , put the 2 x4 in between the front idler and the track after you take out the bleeder screw and remove the bottom bolt completely from the front plate on side the track frame , if not the bolt sticks thru the frame and the adjuster will hit it and not allow it to go all the way back , roll the track and the 2x4 will lift the track up on top the idle , it will loosen the track and make it easy to put a bar thru a hole in the middle of the track and pry against the idler as it is turned and it will jump off , use the bar in between the sprocket and the track to get it off there , you need to have it ja cked up high enough to clear the track guides under the rear idler [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
track removal on T-250
Top