Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Swapping out boss controls to analog gauges
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="TriHonu" data-source="post: 90396" data-attributes="member: 897"><p>&nbsp</p><p>If it stops again, don't touch anything, exit the machine and check your fuel shutoff. If it is closed, it was most likely closed by the BOSS Controller not receiving a signal from the Temp Gauge.</p><p>The basic operation of the BOSS system is to monitor temps and pressures. If any are outside the normal limits, the controller removes the 12v signal to the Fuel Shutoff Solenoid Hold Coil and the machine shuts down to prevent catastrophic damage to the machine.</p><p>The missing Temp Sensor is probably causing an EC-3 (Engine Coolant Wiring Not Connected) error.</p><p>As long as the fault remains, the BOSS Controller will allow restarts, but the timer will continue to shut down the Fuel Shutoff Solenoid Hold Coil after 30 seconds. This allows the operator to run the loader long enough to move/load the machine to get it in for service.</p></blockquote><p></p>
[QUOTE="TriHonu, post: 90396, member: 897"]   If it stops again, don't touch anything, exit the machine and check your fuel shutoff. If it is closed, it was most likely closed by the BOSS Controller not receiving a signal from the Temp Gauge. The basic operation of the BOSS system is to monitor temps and pressures. If any are outside the normal limits, the controller removes the 12v signal to the Fuel Shutoff Solenoid Hold Coil and the machine shuts down to prevent catastrophic damage to the machine. The missing Temp Sensor is probably causing an EC-3 (Engine Coolant Wiring Not Connected) error. As long as the fault remains, the BOSS Controller will allow restarts, but the timer will continue to shut down the Fuel Shutoff Solenoid Hold Coil after 30 seconds. This allows the operator to run the loader long enough to move/load the machine to get it in for service. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Swapping out boss controls to analog gauges
Top