Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Seat bar sensor circuit shorted to ground
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="mrfixitpaul" data-source="post: 24821" data-attributes="member: 2582"><p>13v seems a little low but shouldn't cause a problem. If I remember right the monitoring portion uses only 8v. Maybe check for wiring harness chafed and shorting,pulling the voltage down? I used to make sure the alt was putting out enough by disconnecting the battery neg.terminal while engine was running, if engine quits there is a charging system problem. If it stays running turn on the lights and it still should stay running. Hope this helps</p></blockquote><p></p>
[QUOTE="mrfixitpaul, post: 24821, member: 2582"] 13v seems a little low but shouldn't cause a problem. If I remember right the monitoring portion uses only 8v. Maybe check for wiring harness chafed and shorting,pulling the voltage down? I used to make sure the alt was putting out enough by disconnecting the battery neg.terminal while engine was running, if engine quits there is a charging system problem. If it stays running turn on the lights and it still should stay running. Hope this helps [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Seat bar sensor circuit shorted to ground
Top