Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S175 runs but will not move
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skidsteer.ca" data-source="post: 21632" data-attributes="member: 307"><p>If the machine does not let out a loud "snap" when the green button is pushed then the brake is not releasing.</p><p>First of all there are 4 small orange lites by the green push to operate button. Are they all lit? Especially the traction one</p><p>If the traction one is not, be sure the orange park brake pedal is not kicked forward, its between the rh and lh foot pedals that control the loader and can get stepped on when getting in or out. Failing that check your relays and fuses, (you can swap the relays with each other to test them) located under the metal "bubble" cover on the upright panel between the front of the seat and the operators heals</p><p>Failing that remove the two 3/4" wrench size nuts in the lower front corner of the cab and lift the cab up to access the under seat area.</p><p>In the center of the machine below the front of the seat is a 2" by 4" long cylinder standing on end on top of the chain case. It has 3 large wire about 12 gauge coming from it. Remove the 2 bolts that hold it on and side it straight up off the rod in the center of it. Grab the rod and pull it up about 1.5" and put a hose clamp tightly around it to hold it up. Now your park brake is disabled and the machine will move.</p><p>Ken</p></blockquote><p></p>
[QUOTE="skidsteer.ca, post: 21632, member: 307"] If the machine does not let out a loud “snap” when the green button is pushed then the brake is not releasing. First of all there are 4 small orange lites by the green push to operate button. Are they all lit? Especially the traction one If the traction one is not, be sure the orange park brake pedal is not kicked forward, its between the rh and lh foot pedals that control the loader and can get stepped on when getting in or out. Failing that check your relays and fuses, (you can swap the relays with each other to test them) located under the metal “bubble” cover on the upright panel between the front of the seat and the operators heals Failing that remove the two 3/4” wrench size nuts in the lower front corner of the cab and lift the cab up to access the under seat area. In the center of the machine below the front of the seat is a 2” by 4” long cylinder standing on end on top of the chain case. It has 3 large wire about 12 gauge coming from it. Remove the 2 bolts that hold it on and side it straight up off the rod in the center of it. Grab the rod and pull it up about 1.5” and put a hose clamp tightly around it to hold it up. Now your park brake is disabled and the machine will move. Ken [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S175 runs but will not move
Top