Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S175 axle bearing & cup replacement Questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="wbecker" data-source="post: 99492" data-attributes="member: 9856"><p>I just finished all new axle bearings and chains on my S160. This is how I installed the inner races, after installing the outer race and bearing. I put the race in and tapped it enough for it to stay put. Put the axle in being careful not to make the race fall out. I made a spacer of aluminum that is about 1.4" thick and slides over the axle, i put that on the axle then put the bearing on the axle and put on the sprocket, washer and bolt. Tighten the bolt and the spacer and bearing will push the race in, notice the race goes in just a bit past flush before it bottoms out, make sure it's in all the way. Then take the home made spacer out and reassemble. This is an S160 should be the same. Bill B</p></blockquote><p></p>
[QUOTE="wbecker, post: 99492, member: 9856"] I just finished all new axle bearings and chains on my S160. This is how I installed the inner races, after installing the outer race and bearing. I put the race in and tapped it enough for it to stay put. Put the axle in being careful not to make the race fall out. I made a spacer of aluminum that is about 1.4" thick and slides over the axle, i put that on the axle then put the bearing on the axle and put on the sprocket, washer and bolt. Tighten the bolt and the spacer and bearing will push the race in, notice the race goes in just a bit past flush before it bottoms out, make sure it's in all the way. Then take the home made spacer out and reassemble. This is an S160 should be the same. Bill B [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S175 axle bearing & cup replacement Questions
Top