s160 drive motor bearings

[earlyriser]

Hi, I am taking apart my drive motors in order to replace the seals. Problem is a couple of the roller bearings came out by accident. I'm not sure exactly which bore holes each came from. Is it okay to guess and simply put them back into the bore holes? If not, what do I do next? Thanks

 

[Tazza]

Ideally they should go back in the same hole and the same way up, but as they are out, just put them back where ever you can. Oil them up first, they can be quite tight to get back in.
They should all wear the same, so it shouldn't cause you any issues.

 

[earlyriser]

Ideally they should go back in the same hole and the same way up, but as they are out, just put them back where ever you can. Oil them up first, they can be quite tight to get back in.
They should all wear the same, so it shouldn't cause you any issues.

Thanks!!