Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Skidsteer Classifieds
Wanted
Roll Cage ( ROPS?) For M500
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="mllud" data-source="post: 18860" data-attributes="member: 1012"><p>Some four inch square pipe with 3/16 ti 1/4 inch walls welded up with some corner gussets would be good.You might consider wire mesh on the sides to keep arns inside. It would be better to over do a little. Then your safe. Osha standards can be met with fabrication. Mike</p></blockquote><p></p>
[QUOTE="mllud, post: 18860, member: 1012"] Some four inch square pipe with 3/16 ti 1/4 inch walls welded up with some corner gussets would be good.You might consider wire mesh on the sides to keep arns inside. It would be better to over do a little. Then your safe. Osha standards can be met with fabrication. Mike [/QUOTE]
Verification
Post reply
Forums
Skidsteer Classifieds
Wanted
Roll Cage ( ROPS?) For M500
Top