Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
plow angle
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skayser2" data-source="post: 39221" data-attributes="member: 2179"><p>Thanks guys. For a 2000# machine it works pretty well. Wish I'd had thought to bend the outside foot of the blade width (each end) in about 20 degrees or so before I welded the 3/8" X 2-1/2" angle on the bottom. Think it could have been done on the metal brake without too much trouble. Would have helped pushing without so much tailing off the ends. Will have to come up with some decent wings later. The one in the picture is too small and dosen't work to well. Steve</p></blockquote><p></p>
[QUOTE="skayser2, post: 39221, member: 2179"] Thanks guys. For a 2000# machine it works pretty well. Wish I'd had thought to bend the outside foot of the blade width (each end) in about 20 degrees or so before I welded the 3/8" X 2-1/2" angle on the bottom. Think it could have been done on the metal brake without too much trouble. Would have helped pushing without so much tailing off the ends. Will have to come up with some decent wings later. The one in the picture is too small and dosen't work to well. Steve [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
plow angle
Top