Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
plow angle
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skayser2" data-source="post: 31367" data-attributes="member: 2179"><p>You're right Russ, thanks. I added a 2 1/2" x 2 1/2" x 3/8" angle on the backside of the plow edge. It runs the full width (5') Really stiffened up the lower part of the plow. I also run a 1" poly edge in front of the cutter bar so it's alittle more forgiving. I did bend it the first time I used it but was able to straighten it out by turning it 180 degress and bumping it against a curb a few times. Not a bit of problem since I added the angle iron. Good point Russ.</p></blockquote><p></p>
[QUOTE="skayser2, post: 31367, member: 2179"] You're right Russ, thanks. I added a 2 1/2" x 2 1/2" x 3/8" angle on the backside of the plow edge. It runs the full width (5') Really stiffened up the lower part of the plow. I also run a 1" poly edge in front of the cutter bar so it's alittle more forgiving. I did bend it the first time I used it but was able to straighten it out by turning it 180 degress and bumping it against a curb a few times. Not a bit of problem since I added the angle iron. Good point Russ. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
plow angle
Top