Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
melroe bobcat 610 bent drawbar removal
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="rjardo" data-source="post: 86358" data-attributes="member: 9710"><p>My drawbar was bent when the previous owner dropped something VERY heavy on it. It was nearly impossible to release the bucket, with lots of beating and swearing required.. I did get it partially straightened by heating it cherry red and prying it back, tho there's no really good way to get leverage in there. Now I've decided to remove it to get it working better. I think it's a hollow tube with pins at each end held by small roll pins. I got one of the roll pins out, but there is no good way to get the large pin out of the end, and I'm afraid to drive it in.. Has anybody ever pulled one of these out before and what's the best way. I can straighten the drawbar on my press once i have it out, but not having any luck so far.. Thanks!</p></blockquote><p></p>
[QUOTE="rjardo, post: 86358, member: 9710"] My drawbar was bent when the previous owner dropped something VERY heavy on it. It was nearly impossible to release the bucket, with lots of beating and swearing required.. I did get it partially straightened by heating it cherry red and prying it back, tho there's no really good way to get leverage in there. Now I've decided to remove it to get it working better. I think it's a hollow tube with pins at each end held by small roll pins. I got one of the roll pins out, but there is no good way to get the large pin out of the end, and I'm afraid to drive it in.. Has anybody ever pulled one of these out before and what's the best way. I can straighten the drawbar on my press once i have it out, but not having any luck so far.. Thanks! [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
melroe bobcat 610 bent drawbar removal
Top