There is a part called a load check that is meant to prevent this happening, they are normally hidden under plugs near where the high pressure lines join to the metal tube lines on each segment.I'm assuming it's the valve that needs rebuilding, but was just wondering if there was some other linkage that might be responsible for it. Any help is appreciated. Thanks
Thanks for the post. I cannot find one in the parts list anywhere unless they call it something else.There is a part called a load check that is meant to prevent this happening, they are normally hidden under plugs near where the high pressure lines join to the metal tube lines on each segment.
I have never seen one fail and have a load drop, but i was told that this is what they prevent, so it's possible that this is the cause.
There are no other linkages that can cause this to happen.
and also wouldn't it then drop for tilting?Thanks for the post. I cannot find one in the parts list anywhere unless they call it something else.
In the parts diagram, look for parts that are spring loaded with a cap behind them.and also wouldn't it then drop for tilting?