General Chaos
Member
- Joined
- Jan 11, 2010
- Messages
- 9
Anyone know if trans-hydraulic oil can get too thick in the cold to make the hydraulics guit? I've used my M500 in colder weather than this and have never had a problem. It started shortly after first using it today. The hydraulics were a bit jerky and whined a little but still worked. After about 20 minutes, no more lift or tilt. Its in the shop now warming up. There is a filter under the floor boards. Could this get restricted enough to shut down the hydraulics? I installed a new pump about three years ago. I'll check if its still hooked up to the motor. Any suggestions? Thanks.