I recently brought my bobcat 853h in a shop to have the axle bearings and chaincase bearings changed. They also replaced hydraulic oil filters. They put 10 gallons of hydraulic oil in hydraulic tank. When I went to pick it up it was growling. Checked tank. Nothing on lipstick. Put in about 4 gallons. Got home and started up to unload and was growling again. No oil on lipstick. Put in 3 gallons. Very little oil leaking out. Ran about 10 minutes started growling again and bucket would not lift. No oil again. Where is this oil going? If I have a blown shaft seal on drive motor , can oil be draining into gearcase? every thing was working fine until I brought it to shop. Any possibilitythey couldhave hooked hoses up wrong on reassembly?