Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 15687" data-attributes="member: 82">I can't get a full picture of this setup in my head, but there is a lot of force in this area any extra strength you can provide will be an advantage. Its a good idea to make it so you can easily remove the pin to replace it if needed. Try and weld both side of the mounting plate, preferably with a stick welder and not MIG. MIG welders i have found with standard home hanyman gas just don't have the penetration needed, the gas is formulated to give *pretty* welds. I personally used ferrocraft 11 for the first pass, they are a rutile rod that is a real pain with an AC welder then went over the top with ferrocraft 61 to give a nice finish.If you can give a few pictures that would be an advantage.I hope your repair goes well.</blockquote>