Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Lining up Engine and Pump 853
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="brunsyeah" data-source="post: 12452" data-attributes="member: 1421"><p>Its an isuzu 4jb1 engine. I was not sure if they used the isuzu engines in any other bobcats. Its not an issue of cone length, at the least it would be an issue of pinion diamer/flywheel diameter. These are both bobcat parts that I have and are built for the 853. That doesn't tell you much though if this is not a bobcat engine. I see no reason why it wouldn't be though! I will get some pictures tmr. Skidsteer.ca, I think there may be an issue with the housing being correctly, if at all, attached to the engine? So my next question is, is anyone familiar with where the mounts are that attach the housing to the engine. Visually, the engine needs to move toward the rear of the unit in order to correctly mesh with the starter pinion..... I have a feeling there are some more bolts not correctly, if at all installed to locate the engine correctly to the bellhousing. Any words on the 4 carriage bolts?</p></blockquote><p></p>
[QUOTE="brunsyeah, post: 12452, member: 1421"] Its an isuzu 4jb1 engine. I was not sure if they used the isuzu engines in any other bobcats. Its not an issue of cone length, at the least it would be an issue of pinion diamer/flywheel diameter. These are both bobcat parts that I have and are built for the 853. That doesn't tell you much though if this is not a bobcat engine. I see no reason why it wouldn't be though! I will get some pictures tmr. Skidsteer.ca, I think there may be an issue with the housing being correctly, if at all, attached to the engine? So my next question is, is anyone familiar with where the mounts are that attach the housing to the engine. Visually, the engine needs to move toward the rear of the unit in order to correctly mesh with the starter pinion..... I have a feeling there are some more bolts not correctly, if at all installed to locate the engine correctly to the bellhousing. Any words on the 4 carriage bolts? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Lining up Engine and Pump 853
Top