Kubota V3307 engine parts

[larabeejj]

I have a 2019 TL10V2 engine assembly that was running but had a tapping noise in the engine when I bought it used. I swaped out the motor. Message me if you need any parts from the motor. I have fuel supply pump, injectors, engine harness, DPF etc. [email protected]

 

[Lakecrest]

Interested in injectors and pump

 

[cogniz]

Any chance you have the shop manual on the V3307?

 

[rsjohnsn]

Did yours have àc? My machine had the ac removed before I got it and I want to put it back on. I need the bracket and compressor for sure and most likely everything else. I have found a couple of brackets but I'm not sure which one I need. Could you possibly get me a picture of the bracket?

 

[cogniz]

Did yours have àc? My machine had the ac removed before I got it and I want to put it back on. I need the bracket and compressor for sure and most likely everything else. I have found a couple of brackets but I'm not sure which one I need. Could you possibly get me a picture of the bracket?

Yes the machine came with AC and to my surprise, it worked. Give me a few, I'll get some pics for you.

 

[rsjohnsn]

Thanks! For some reason, the previous owners removed the heater and ac, but all the controls and vents are still there. I can't figure out why they would do this on a machine that only has 2100 hours on it.

 

[cogniz]

That makes no sense...I've got this on my calendar for tomorrow. Holler with anything else.

 

[rsjohnsn]

Will do, thanks again!

 

[cogniz]

Hey RS. Snow storm slowed me down. Attached are some bracket and mount photos. Holler if you need measurements or specific photos.

 

[rsjohnsn]

You did good, thank you very much. That is different than what I saw but then again I'm not sure if they were correct. That doesn't look to hard to make and I could even make the adjustment into the bracket. This gets my mind to working.