Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
John Deere Skidsteer Forum
Injector pump problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 51018" data-attributes="member: 82"><p>I removed the ridge on a Kubota i got off ebay years ago with a die grinder and what they call spyro bands over here. They are like sandpaper in rings that you slide over a rubber adaptor to hold them in. Just go slowly and only as far as the ridge, any lower and this is where the rings seat. Not as acurate as a propper ridge remover though, but its what i had access to. That engine ran better than any other that i did up properly too..... Started without even glowing.</p><p>It wouldn't hurt to measure the bores too, if they are too worn, its really not worth you going too much further without looking up prices for over sized pistons/rings and machine work.</p></blockquote><p></p>
[QUOTE="Tazza, post: 51018, member: 82"] I removed the ridge on a Kubota i got off ebay years ago with a die grinder and what they call spyro bands over here. They are like sandpaper in rings that you slide over a rubber adaptor to hold them in. Just go slowly and only as far as the ridge, any lower and this is where the rings seat. Not as acurate as a propper ridge remover though, but its what i had access to. That engine ran better than any other that i did up properly too..... Started without even glowing. It wouldn't hurt to measure the bores too, if they are too worn, its really not worth you going too much further without looking up prices for over sized pistons/rings and machine work. [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
John Deere Skidsteer Forum
Injector pump problem
Top