Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydraulics problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="spitzair" data-source="post: 90005" data-attributes="member: 3333"><p>Are you absolutely sure it's not the wiring? Sometimes wires can corrode and/or break inside the insulation and you'll never find it just by looking at it, you have to pretty much ring out every wire to be sure but it could save you 500 big ones... I had major electrical problems on an EX200-2 Hitachi a few years ago and even though all the wiring looked good from the outside, it was all junk. Worked, then didn't work, then would sort of work, then quit for good... I ended up rewiring the entire machine and it works like new now. The fact that your aux. stopped working, then worked again, then stopped, especially after you were in there wiggling wires and stuff leads me to believe wiring is the culprit. I would ring out all the wires between the module and switches, module and coils and wherever else the wires for the aux circuit run just to eliminate that possibility.</p></blockquote><p></p>
[QUOTE="spitzair, post: 90005, member: 3333"] Are you absolutely sure it's not the wiring? Sometimes wires can corrode and/or break inside the insulation and you'll never find it just by looking at it, you have to pretty much ring out every wire to be sure but it could save you 500 big ones... I had major electrical problems on an EX200-2 Hitachi a few years ago and even though all the wiring looked good from the outside, it was all junk. Worked, then didn't work, then would sort of work, then quit for good... I ended up rewiring the entire machine and it works like new now. The fact that your aux. stopped working, then worked again, then stopped, especially after you were in there wiggling wires and stuff leads me to believe wiring is the culprit. I would ring out all the wires between the module and switches, module and coils and wherever else the wires for the aux circuit run just to eliminate that possibility. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydraulics problem
Top