Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydraulics problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="little_fellow" data-source="post: 89731" data-attributes="member: 3098"><p>I'm reopening this old post. Never did solve the problem. I've checked the hand controls with a ohm meter and I get o resistance when activated. I checked the coils by removing them and applying voltage from a separate source and they do magnetize. I checked for voltage going to the coils and I get little voltage(about .45 volt for one connector and 1.07 volt on the other). When the connectors are connected, the coils do not magnetize. I get similar low voltage when I probe at the hand controls. I am wondering if even though the two light in the dash do come on when activated, is it possible the wiring immediately after the light could have come loose?</p></blockquote><p></p>
[QUOTE="little_fellow, post: 89731, member: 3098"] I'm reopening this old post. Never did solve the problem. I've checked the hand controls with a ohm meter and I get o resistance when activated. I checked the coils by removing them and applying voltage from a separate source and they do magnetize. I checked for voltage going to the coils and I get little voltage(about .45 volt for one connector and 1.07 volt on the other). When the connectors are connected, the coils do not magnetize. I get similar low voltage when I probe at the hand controls. I am wondering if even though the two light in the dash do come on when activated, is it possible the wiring immediately after the light could have come loose? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydraulics problem
Top