Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydraulics problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="little_fellow" data-source="post: 67424" data-attributes="member: 3098"><p>I have the cheap type ohm meter with the needle instead of being digital. I have adjusted it to zero in when touching the two probes together and after doing that I checked the resistance in the switch on the hand control and I am getting pretty much a zero reading and if there is resistance from the wire, it is not high enough to notice. Are you saying that this is indicating a bad switch? If this is the case, I will attempt to do like you say with the jumper wire.</p></blockquote><p></p>
[QUOTE="little_fellow, post: 67424, member: 3098"] I have the cheap type ohm meter with the needle instead of being digital. I have adjusted it to zero in when touching the two probes together and after doing that I checked the resistance in the switch on the hand control and I am getting pretty much a zero reading and if there is resistance from the wire, it is not high enough to notice. Are you saying that this is indicating a bad switch? If this is the case, I will attempt to do like you say with the jumper wire. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydraulics problem
Top