Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydraulics problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="little_fellow" data-source="post: 67329" data-attributes="member: 3098"><p>Thanks Tazza. I didn't do anything yet. Kind of building up courage and wisdom to do this. Trying not to screw-up like I did with the stems. Once I do find the three wires, how do I use the ohm meter. I assume that I keep the wires connected to the connector. I assume one wire is for the left side of the switch and the other two are for the ground and the other side of the switch. Should I pierce the outer cover of the wire to do the testing? What Kind of ohm reading will I get if it is faulty? If I do get the 0 ohm reading , what do I do next? Does it mean the switch is good and that the control module is bad? Is there a way to test it?</p></blockquote><p></p>
[QUOTE="little_fellow, post: 67329, member: 3098"] Thanks Tazza. I didn't do anything yet. Kind of building up courage and wisdom to do this. Trying not to screw-up like I did with the stems. Once I do find the three wires, how do I use the ohm meter. I assume that I keep the wires connected to the connector. I assume one wire is for the left side of the switch and the other two are for the ground and the other side of the switch. Should I pierce the outer cover of the wire to do the testing? What Kind of ohm reading will I get if it is faulty? If I do get the 0 ohm reading , what do I do next? Does it mean the switch is good and that the control module is bad? Is there a way to test it? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hydraulics problem
Top